شاركنا تاريخ ميلادك!
تاريخ الميلاد
تاريخ الميلاد المدخل غير مكتمل يرجى ادخال تاريخ ميلاد صحيح
×
مقياس حرارة الطعام CDN IRT220 ProAcaccurate Expanded Range, 1.75-inch/4.4 cm Magnified Dial
36.61 ريـال

مقياس حرارة الطعام CDN IRT220 ProAcaccurate Expanded Range, 1.75-inch/4.4 cm Magnified Dial

بواسطة  CDN، أدوات قياس للمطبخ -  455 تقييم

36.61 ريـال 

+ 23.93 ريـال التوصيل إلى السعودية
هذا المنتج يشحن و يباع من قبل Amazon Global Store US
العلامة التجارية
CDN
اللون
S/S
المادة
هل يتطلب هذا المنتج بطارية او يحتوي بطارية
ميزات المنتج:
  • Measurement Range: 0 to 220°F
  هل هذه السلعة غير مناسبة؟ بلغ عن اساءة

بلغ عن اساءة

ساعد سوق في تحديد السلع غير المناسبة عن طريق الإبلاغ عن الإساءة.

شكراً لك!

لقد تم استلام ملاحظتك، سوف نقوم بمراجعتها بأقرب وقت.

البائع
  • يتم بيع المنتجات العالمية من الخارج وقد تختلف عن المنتجات المحلية، بما في ذلك الملاءمة وتصنيف العمر ولغة المنتج ووضع العلامات أو التعليمات.
  • خدمة العملاء محلية مع توفر خدمة الإرجاع السهلة خلال 30 يوماً.
  • إن أي تفاصيل عن كفالة المنتج تابعة للمشتريات التي تتم في الولايات المتحدة الأمريكية. قد لا تكون الكفالة سارية المفعول في المملكة العربية السعودية.
  • يشمل السعر جميع رسوم الاستيراد والضرائب عند الشراء.

تطبق الشروط المنفصلة

معلومات المنتج

  •  

    المواصفات

    UPC-A
    786377189035
    العلامة التجارية
    CDN
    اللون
    S/S
    المادة
    UPC-A
    786377189035
    العلامة التجارية
    CDN
    اللون
    S/S
    المادة
    الرقم المميز للسلعة
    2724659229022
    ASIN
    B000A3L614
    دي جي
    هل يتطلب هذا المنتج بطارية او يحتوي بطارية
    إقرأ المزيد
  •  

    الوصف:

    IRXL220 Features: -ProAccurate collection. -Waterproof. Product Type: -Dial. Food Type: -Meat. Commercial Use: -Yes. Dimensions: Stem Length: -5". Overall Product Weight: -1 lbs.

 

تقييمات المستخدمين

0
لا يوجد تقييمات بعد
كن أول من يقيِّم هذا المنتج
قيِّم هذا المنتج:

شكراً على التقييم ! اكتب تقييماً مفصلاً
3.4
3.4 من 5
455 تقييم
5 نجوم
(248)
4 نجوم
(72)
3 نجوم
(28)
2 نجوم
(27)
1 نجمة
(80)
قيِّم هذا المنتج:

شكراً على التقييم ! اكتب تقييماً مفصلاً
التقييمات الأكثر فائدة على Amazon.com
  • Incubation of chicks needs THIS one. Don't go cheaper!
    بواسطة Melissa في 19 April 2016

    Calling all chicken people! This is what you want to buy for your wet and dry bulb temps if you are incubating chicks. I checked and it came perfectly calibrated. It was the 5th one I bought. All the others were a little cheaper pricewise, but a lot cheaper in quality. Had I believed any of the other 4 I would have killed my $200 worth of rare breed chicken eggs. Glad I got this one at last! Included a picture of the nice LARGE dial and handy calibration tool being used to check calibration. The tool has a slot at one end to slide the probe through so that you don't have to touch it with your hands which can throw off the temp and also get you burned if you aren't careful. It also has the built in wrench tool so that you can turn the adjustment nut should you find that you need to. Just look up your altitude adjusted boiling temp (mine is 210) and then fill a big pot with distilled water and put it on to boil. Then fill a tall glass with ice and distilled water. After 3 minutes, with the thermometer in the slot of the tool you carefully set the probe down into the water without touching it to the actual glass. It should read 32 degrees F. Make a note of what it DOES read. Take it out and let it come to room temp. Then do the same to the pot of water once it has reached a true boil. Avoid placing it directly into the path of bubbles as the steam can alter the test some. When the temp stops climbing and holds steady write that temp down. My temps were 34 and 208. So it was 2 degrees high at freeze and 2 degrees low at boil. That is OK. All that matters is that it is centered. It is set to the middle of the spectrum between freeze and boil. If it is off more one way or the other you will adjust it to get it centered.

    19 شخصاً وجدوا هذا التقييم مفيداً

    تم النشر على Amazon.com

  • Easy to Read bi-metal Thermometer
    بواسطة Lotus-Seven في 27 September 2017

    Easy to read bi-metal thermometer I purchased two of these to monitor inlet and outlet air temperature of a air handler. First checked them against a reference "Type K" thermocouple probe known to be accurate to +/- 0.1deg F. Both read 81 deg F. at a true bath temp of 79.6 deg. F. so were reasonably well calibrated from the factory. Like many bi-metal dial thermometers, these can easily be re-calibrated if necessary. The supplied pocket-clip can be used to turn the adjusting nut on the back of the dial to calibrate.

    Both thermometers were installed in our air handler by inserting the probes into 0.150 inch drilled holes. They respond quickly (several seconds delay) to air temperature changes, but they do have some slight "stiction" so don't always respond smoothly to small changes of less then +/- 2 deg. F. A slight "tap" on the dial will correct the reading if the temp change is small.

    Note: if you re-calibrate using an ice bath you should be aware that the actual water bath temp will usually stabilize at 33.5 to 34 deg. F. depending on the conductivity and surface area of the container. Not the commonly thought ice melting temp of 32 deg. F. Calibrate accordingly. If you used boiling water you should check a barometer and a boiling point vs. atmospheric pressure chart for the correct calibration temp. as it can vary significantly from the commonly expected 212 deg. F.

    One comment: Although it does not affect my use of these thermometers, it should be noted that the supplied pocket clip plastic holders provided had undersize holes for the probe and were so tight fitting as to be almost useless. Inserting the thermometer in the pocket clip will keep it stored in your pocket, but will make quick removal difficult. Possible this may loosen up with use, but new they are way too tight.

    Bottom line: Easy to read, fairly accurate from factory, able to be re-calibrated, fast response time.

    8 أشخاص وجدوا هذا التقييم مفيداً

    تم النشر على Amazon.com

  • Quick reading and pretty accurate
    بواسطة Vaughn T. Hangartner في 31 August 2016

    For those that see the word OVEN and think you can _leave this in the food IN an oven_, you are mistaken! The lens is polycarbonate, not pyrex so it WILL melt. This is not that kind of probe. Open the door, insert, wait 20 or so seconds to see if the meat is at the right temp, then remove. If you need an oven proof probe, look for and Oven Proof Thermometer or similar.

    Insta-Read also seems to vex users, this is a bimetallic thermometer, it is quick, but it is not instant, NO bimetallic is instant. It is however far far FAR faster than a traditional alcohol or mercury capillary tube thermometer! If you really, genuinely need 'Instant', get a digital probe, and then keep button cell batteries on hand for when you discover the batteries have gone dead on Thanksgiving day.

    Anyway, this probe works pretty well. It is stoutly made, but not in China, instead, it's Vietnam. The dial is easy to read meaning I don't have to find my glasses to see what it's reading. The crystal/lens is polycarbonate so it's shatter resistant if you drop it on a hard floor. It comes from the factory reasonably well calibrated, mine was one degree cool. Calibration is very simple and the plastic protector sheath has the hex drive to adjust it.

    If you need an exactly calibrated probe, you will need to get a 'Certified' one, and you won't find one in the less than $10 range.

    10 أشخاص وجدوا هذا التقييم مفيداً

    تم النشر على Amazon.com

  • You'll RUIN your meat if you depend on this
    بواسطة cherie price في 01 February 2019

    It's not accurate or even close. I totally ruined a $25 thick steak on my grill because of this thermometer. For MR, I was supposed to cook it to 120 degrees. Did so. Let it sit for 10 minutes as required to keep the juices flowing -it's still cooking off the grill. If you go by this thermometer, you'll end up with something resembling shoe leather. Plus all meat therms I've had in the past, have had written info right on the face. Eg. Medium Rare Beef 120 deg. Etc. DONT TRUST THIS ONE!

    شخصان وجدا هذا التقييم مفيداً

    تم النشر على Amazon.com

  • Good product. Reasonably accurate.
    بواسطة M. Nomine في 13 November 2018

    I bought this to measure my car air conditioner temperature at the vent, and it works well for that. I calibrated the thermometer with boiling water and it was accurate. The thermometer is not poorly constructed but it's not heavy-duty either. I gave it 4 instead of 5 starts because I feel like some care must be taken not to bang it around too much or it could fall out of calibration or become damaged. However for the price this product offers a good value. Pro tip: To get this thermometer to stay in the car air vent without spinning around, find a scrap piece of dense plastic foam, like packing foam, and cut a small piece that will stick into the air vent. Then stick the thermometer through the foam. The foam will hold the thermometer in place and keep it from spinning.

    تم النشر على Amazon.com

إعلانات مُموَّلة لك

×

الرجاء تأكيد رقم هاتفك الجوال لإكمال عملية الشراء

سنقوم بإرسال رسالة نصية تحتوي على رمز التفعيل، الرجاء التأكد من رقم هاتفك الجوال ادناه، ثم انقر على زر "أرسل رمز التفعيل".